Specifications:

Power Source: internal 12Volt (Type 23A)

Frequency Bands:403.55/433.92MHz

Transmission Power: 350mW

Current Consumption: 9mA active

Physical Size: 65 x 32 x 14mm

Weight: 30g

Features:

Tri-Colour Led

User Prorammable Buttons(4 in Total)

How to Learn Transmitters into the Remote

The Following procedure explains how to learn existring transmitters

into your sentry Learning Remote Control.

For Best Results the transmitter to be learnt MUST be placed in close proximity

to the recieving Antenna.

Step 1.

Press and Hold the button that you would like to learn, after 3-4seconds the LED

will begin to flash red, indicating 403MHz BAnd is currently selected.

Step2.

Release the button ,The LED Remains Flashing.

To Change the Frequency Band , Press same Button Again,

The LED will Change Flashing to GREEN Indicating the 433Mhz Band is Currently Selected.

NOTE:Pressing any Other Button at this point aborts the processand exits Learning Mode!

Step 3: If The Code Is REconized, The LED Will Flash Three times

and then the programming mode is exited and the information from

the other other transmitterIs Stored in Memory. If the coding is reconized,

the remote will automatically store it with the correct Frequency band allocation.

For Example if a code-hopping remote is learnt into a button, the system

Will Automatically Set The Frequency band for You.

Step 4: If a Code Hopping Transmitter is being cloned, you must Re-Learn

the new transmitter(i.e this Transmitter) into the Existing Reciever.

As Per Instructions for that reciever.Failure to do so will result in the reciever not

Responding to this new transmitter.